News

A team of applied industrial electronics students at Aalborg University in Denmark has built and tested a 3D-printed hybrid drone that can take off, plunge underwater, maneuver beneath the surface and ...
The airframe was printed using a Bambu Lab A1 3D printer, a desktop device Xu used to manufacture the composite parts required for the drone’s airframe and flight surfaces.
4 thoughts on “ 3D Printed Mini Drone Test Gimbal ” pelrun says: October 9, 2023 at 2:01 am It’s the Matrix, but for drones instead of humans! Report comment. Reply.
3D printing isn’t just for supercars, now it’s for drones, too Organic-looking designs consolidate parts numbers and cut mass by up to 40 percent. Jonathan M. Gitlin – Aug 10, 2023 2:53 pm | 112 ...
For propulsion, attitude, and depth control, the CPS 5 has five brushless drone motors with 3D printed propellers, which are inherently unaffected by water as long as you seal the connectors.
The 3D-printed drones cost between $2,000 and $3,000 each. The biggest challenge has been getting parts approved by the Defense Department.
The team’s drone, built using 3D printing technology, features custom sensors that measure wind speed, pressure, and GPS tracking. Unlike traditional drones, this model is designed to withstand ...
RIA-JMTC is actively preparing to build the capacity for large-scale production of 3D-printed drones, working in close collaboration with other key OIB facilities, such as Tobyhanna Army Depot.
Grynkewich highlighted the group’s new Kestrel, a 3D-printed drone. “We can make this thing for about $2,500,” he said. “It can go roughly 100 kilometers, so not a huge range, ...