Soon after the burst starts, the sine wave will drop below the threshold and the comparator’s output will fall—remaining low for one-half cycle of the sine wave. When you set the triggered burst to ...

For a sine wave source, a non-power factor-corrected PC will typically exhibit a crest factor of 2 to 3. For a source waveform that is a stepped approximation to a sine wave — as used in most ...

One such gem of analog design was the SG505, ... [Bruce] can shove arbitrary waveforms out of the chip without using any CPU cycles. By writing a sine wave, ...

Let’s consider one more waveform—the noisy, messy sine wave shown in Figure 6. The true rms meter pegs it at 348.99 mV, which is close to the digital scope’s measurement of 345 mV.

The figure shows the schematic for the square-wave-to-sine-wave converter. A crystal and a 10-MO resistor are connected across pins 5 and 6 of the RDD104. A 100-pF capacitor (C5) is tied to pin 5.