News

To center the rudder pedals and joystick, a couple of long tension springs were added. The joystick (left) and rudder pedals (right) magnet configurations with a hall effect sensor.
Pilots watch for drift during takeoff roll and apply rudder with the rudder pedals. On some airplanes at lower speeds it may be necessary to add a bit of nose-wheel steering to achieve the desired ...
One potential advantage the TPR has over the Slaw Device pedals I’m currently using is a higher axis sensor precision—the Slaw Device pedals have 13-bit precision for the main rudder axis and ...
On Feb. 6, the rudder pedals on a United Airlines Boeing Max 8 became stuck as the plane rolled down the runway after landing at Newark Liberty International Airport in New Jersey.
Saitek’s Pro Flight Combat rudder pedals cost about $200 and are often held up as being a good enthusiast choice, but anecdotally it sounds like they suffer from the same long-term problems as ...
On Feb. 6, the rudder pedals on a United Airlines Boeing Max 8became stuck as the plane rolled down the runway after landing at Newark Liberty International Airport in New Jersey.
The rudder pedal system on the aircraft is identical to that of the 737 NG. Boeing said it was aware of two similar past occurrences on the 737 NG model, both in 2019, which were resolved with ...
The National Transportation Security Board (NTSB) is looking into an incident involving a 737 Max plane that experienced "stuck" rudder pedals during its landing rollout.
The National Transportation Safety Board is investigating an United Airlines 737 MAX 8 flight last month that experienced "stuck" rudder pedals.
The agency is in the midst of investigating a February incident in which the rudder pedals on a United Airlines Boeing 737 Max 8 were "stuck" in their neutral position during the landing rollout ...
The head of the National Transportation Safety Board blasted the Federal Aviation Administration, saying the agency is not taking seriously enough the potential for jammed flight controls on some ...